Gecko Hi Limit Sensor / Probe
For use with SSPA / MSPA-MP Control Packs
Gecko SSPA & MSPA-MP High limit Sensor/ Probe.
This Gecko sensor provides a safety cut-off if the water temperature becomes too hot due to a defect elsewhere in the control system. It is designed for S-Class (SSPA-1 and SSPA-2) and MSPA-MP control systems.
This sensor has a little two-pin plug. The wires are typically green and purple in the Gecko version, and red and black in the HydroQuip version, but there are compatible probes on the market in other colours.
Replaces Gecko
- 9920-400516
- 9920-400902
- 9920-400435
- 9920-400643
- 9920-400523
Note lead length on some of the sensors this replaces may differ
Dimensions
- Cable: 180 cm
- Probe Diameter: 6.3 mm
Part numbers
- Gecko: 9920-400446
Important Information:
Our ranges must be installed by a competent individual or tradesman, that is trained within the industry. Spa Packs and other computerised equipment are exempt from our returns policy if they have been opened or installed. If the spa pack is suspected as being faulty, it will need to be returned to us within the warranty period and will then be forwarded to the manufacturer for inspection. If deemed to be faulty, we will replace under warranty. If the board is not at fault or is found to have been damaged due to installation, an additional charge will be required to cover the costs of shipping and return.
Please ensure this is the correct Spa Pack as this item is non-refundable - If you are unsure, please contact our friendly customer service team for advise & support
